Cancelled

Your job is rejected! Reason:
I need an electronic circuit Arduino designed and built to control a Stepper motor.

General information for the business: Animal feeders Kind of development: New program from scratch Num. of modules: 1 Description of requirements/functionality: Project design to control a Bi Polar stepper motor using ideally an Arduino. The Project is for design, code and supply a working prototype here to the Uk. 1. Radio Control turn circuit on ( press 1) LED turns green, possible sounder 2 sec burst confirmation. 2. Radio Control select program 2-6 3. Random delay before Bi polar motor activation. ( between 2-10sec ) 4. Random turn stepper motor +90 or -90 ( +90 Clockwise, -90 Anticlockwise ) 5. Fixed delay after first activation say 1.5 seconds 6. Return to Zero position ( If step 4 random selection was +90 then return should be -90 & vice versa ) 7. Random delay between (2-10 sec) 8. Start loop again back at step No:-4 9. Loop continues until a fixed number of cycles has been completed ( Say 10 Cycles ) 10. Stop! Buzzer sounds to confirm cycle completed ( Say 2 seconds burst ) 4 programs selectable from the radio control channels 2-6 all to run as above but with a different fixed variant on step 5. Each program has an LED confirmation. So 6 LED’s in total. Arduino Platform and buzzer parts. Something like a Nema 14 Bi Polar stepper motor, and suitable driver. 12v 6 channel RF 433Hz Radio control 100m range or equal. The project is to design, code, and supply a working prototype unit for testing to the UK. Payment once agreed say something like 50% on design and the rest on shipping and successful testing here in the UK. Best regards Extra notes:

Additional info

Job: #10073

417 day(s) 18h 21m

Budget:

$86

Job type:

One time job

Working Hours:

00:00 - 08:00

Days per week:

5

Required skills
Assembler, C#, Delphi,
Posted by

Mobile:

N/A

()

Get the job done

To apply for this job you must first login/signup.

click here to learn How It Works

Invite
FAQ

click here to learn how StartAJob platform works?

Write then in the "Write a note or message to the customer"

You already have the estimated cost and time to complete the work you are in the fields "Execution time" and "Payment requested" or leave them empty and can be changed later.

If you can get the job done, place your offer in the form bellow or if you have additional questions, you can write them in your remarks field and leave the “desired salary” and “completed within” fields empty. They could be set later.